IR In-Situ Probe Analyzer

The AIM Series 9010 is the IR probe design of the very popular E-6200 IR In-Situ Stack Gas Monitors: featuring dual beam, dual wavelength rationing, double-pass, non-dispersive infrared (NDI R) analysis.

These instruments incorporate mechanical and optical features which have been refined through over 30 years of practical field experience, state-of-the-art design, and over 4,000 installations world-wide. AIM is experienced in the development, installation, operation and compliance testing of emissions monitoring instrumentation.

This includes single and multi-component UV, VIS, and IR absorption gas analyzers, gas filter correlation analyzers, transmissometers, single and multiple-pass optical systems, fiber-optic coupled systems, and long-path (open-path) ambient analyzers.

Features

• Patented Technology with Over 30 Years Experience
• Single Penetration of Gas Stream
• Calibrate In Place In the Probe
• Expandable To Measure Six Gases Standard, Ten On Special Order
• Meets US and International EPA, State and Local Agency Requirement
• Accurate Measurements
• Fast Response
• Automatic Calibration
• Automatic Temperature Correction
• Digital Circuitry and Signal Transmission
• Stable Alignment
• EPA-Approved In-Place CGA Calibration Verification
• Proven Design
• Expandable
• Low Maintenance

Ranges

Adjustable from ppm to percent (%) levels, depending upon pathlength; multiple outputs/ranges available.
Typical System Configuration:
SO2 0 - 1000 to 0 - 5000 ppm v/v
NOx 0 - 250 to 0 - 2500 ppm v/v
CO2 0 - 5 to 0 - 30% /vol
CO 0 - 100 ppm v/v to 0 - 10%
HCI 0 - 100 to 0 - 1000 ppm v/v
H2O 0 - 25 to 0 - 40%
Accuracy: Better than ± 2% of full scale
Repeatability: Better than ± 1% of full scale
Linearity: Better than ± 1% of full scale
Zero Drift: Less than ± 1% of full scale in 30 days
Span Drift: Less than ± 1% of full scale in 30 days
Response Time: 1 to 15 minutes, Typ., operator selectable

In-Situ Probe Analyzer Brochure
click on image to open